METAL HOSE

TEST PROCEDURES

 

FLX-010 GAS PRESSURE TEST PROCEDURE                  Dated: November 1, 2018     REV: C
Page 1 of 5
Flexline
Controlled Document
1.0 INTRODUCTION
1.1 The purpose of this procedure is to specify the pressure test
requirements for Metal hose assemblies.
1.2 All testing shall be in accordance with customer drawings or internal requirements.
Where specific customer requirements are not specified, this procedure will apply.
1.3 Every hose made must be leak tested as described below. Structural tests will only be performed at the request of the customer.
1.4 All pressure test gages used for final inspection will be repurchased yearly.
1.4 The operator or designated personnel will be responsible for performing tests and recording results.
For Full Information, please contact Flexline

    Your Name (required)

    Your Email (required)

    Your Phone (required)

    Subject

    Your Message

    Attachment